I have two boats, on my fishing boat I have an HD side imaging transducer in addition to an XP-9-20 thru-hull transducer connected to the 798 with the Y cable - everything works as it should. On my non-fishing boat I just have the SP-9-20 epoxied in the hull and have yet to have it work properly. I'm afraid the answer is just that it's not going to work for whatever reason, but want to pick the brains of some experts before I give up on it.
First off, I was stupid and accidentally cut the transducer cable. I've spliced the coaxial cable, soldered it, and wrapped it in electrical tape. I'd think this should be an acceptable fix for the relatively low frequencies involved (If we were dealing with a few hundred MHz I could see where this wouldn't work, but at just a few hundred kHz I'm assuming it shouldn't be a problem). Am I 'all wet' on this assumption?
I've tried the thru-hull transducer connected to the 798 both directly and with the Y cable with identical results, a continuous readout of about 3 feet. I tried all 3 settings for the transducer select option and nothing works.
Any help is greatly appreciated.