« previous next »
Pages: [1]   Go Down

Author Topic: TH Marine holeshot plate  (Read 5255 times)

0 Members and 1 Guest are viewing this topic.

Offline Meena

  • Newbie
  • *
  • Joined: Dec 2013
  • Location: IN
  • Posts: 10
  • Unit(s): 798
TH Marine holeshot plate
« on: January 25, 2014, 07:27:47 PM »
I was wondering if anyone has run into this before and has a solution. I have a transducer shield and wedge to put on my holeshot plate but about an inch from the outside edge of the plate it bends downward and wont allow the wedge to sit flat. What should I do about this?
Logged
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo

 

Related Topics

  Subject / Started by Replies Last post
1 Replies
15765 Views 		Last post May 01, 2009, 07:32:46 PM
by RGecy
0 Replies
6613 Views 		Last post May 10, 2010, 09:15:44 PM
by muskyhunter
3 Replies
7602 Views 		Last post January 08, 2013, 09:58:30 PM
by LocDown
4 Replies
6795 Views 		Last post January 01, 2016, 08:30:25 PM
by buell1965
0 Replies
5710 Views 		Last post July 15, 2016, 02:14:47 PM
by pat.gearhart@icloud.com
0 Replies
4661 Views 		Last post May 29, 2020, 07:39:38 AM
by steelebob
4 Replies
8051 Views 		Last post August 28, 2021, 07:38:11 AM
by 6speedy3
1 Replies
5217 Views 		Last post September 25, 2023, 08:34:32 AM
by jimf


SimplePortal 2.3.3 © 2008-2010, SimplePortal