Holy moly diver ...
And I thought rewiring xducer cable was intense ... I can't imagine rewiring to the internal board ...
Although I don't have the pinout for the wires from the connector to the board ...here is the pinout for the HDSI xducer cable connector ...
Rickie
Heh thanks Rickie, I have this drawing it's the other side of the connector that I failed to document properly that goes to the main board.
It's funny how it goes when you start hacking into these things, I installed it on the boat a year ago and noted that the SI seemed to be reversed. I simple switched the cable connections around and kept going. Of course my memory is not so good on the details. So now that I am replacing the xducer and do not want to cut the cable I am looking at it more carefully to make a short adapter pigtail and want to get it right the first time(or second time). It looks like I switched two wires by accident inside the plotter. So I just need the wire colors on the inside of the connector to confirm my assumptions. The wires are not the same colors on the inside. Yea I did the original mod out of desperation, the original connector just got to be totally unreliable and the service center in Vancouver was not helpful. I have built a tow from a salvaged xducer that I want to connect to the system as well which is also the reason to upgrade to a much better connector.
If anyone even had a photo of the back side of the connector showing the colors of all the connections that would help !!
Thx everyone for looking.