Hello everybody, a month or so ago I had posted about buying a 998c unit. I have purchased the unit and have installed everything on my Nitro Z-7, and have to say everything is working 100% so far. I have taken the boat out 4 or 5 times so far since the installation and my first trip out got picture perfect images! I have a few questions though. First, if you are looking from the back of the boat at the transducer, it is perfectly level with the boat. But if you look from the side of the boat, the transducer is tilted downward a few degrees. I haven't noticed any issues reading the bottom, even at high speeds. (45 mph +, with the 2d sonar) However, when marking fish with DI and 2D, the fish don't quite show the traditional "arc" or "^". It's more of a slightly tilted arc. Could it be because of the angle of my transducer? other than that, the images are perfect. The only other problem I have had is the transducer will kick up at WOT. Is it possible to tighten the bracket so It wont kick up? I know it needs to be able to, but I was hoping to prevent it from kicking up at higher speeds. I have the transducer mounted on the step of my nitro if it helps with anything. thanks in advance, and i'm still mind blown at the things I have found in my home lake already...