Humminbird Side Imaging Forums
		Side Imaging Forums => 798c SI => Topic started by: lolar3288 on July 13, 2015, 11:35:40 AM
		
			
			- 
				All of a sudden my temperature reading is crazy high...150 F and above.  Does this mean I have to replace the whole side scan transducer???
 
 Larry
- 
				Do you still have a temp problem? The post is almost a month old. I get reading like that when the stern is in the sun out of the water. Other than that situation I think your temperature probe is faulty. I would try to clean the connectors before I bought another HDSI though. Bob
			
- 
				Yep, still have the problem except now....no temp reading.  I guess the transducer is shot.  The unit is not that old in my opinion.
			
- 
				I'm pretty sure you could use the remote temp sensor on your 798 and then set the temp readout box to show this temp ... 
 
 http://www.humminbird.com/uploadedFiles/Content/Category/Support/FAQ/Accessory_resource-Guide_2014_X5.pdf (http://www.humminbird.com/uploadedFiles/Content/Category/Support/FAQ/Accessory_resource-Guide_2014_X5.pdf)
 
 I would call HB to confirm ... 1-800-633-1468
 
 Rickie
- 
				Thanks for the reply. Problem is I own a fly bridge cruiser and the unit is on the fly bridge so it is a long and winding wire pull that required an extension.  No easy replacement job!  I was hoping it was a software issue!
			
- 
				Have you examined the transducer cable carefully to make sure there is no damage to it?