Humminbird Side Imaging Forums

General => General Discussion => Topic started by: Wallin8r on May 27, 2015, 09:39:47 PM

Title: Ultera 4 pin connection
Post by: Wallin8r on May 27, 2015, 09:39:47 PM

Can anyone help me with the 4 pin connector on the ulterra?  I assume it's for the US2 but can't find any switch or y connector that looks like it matches to hook to my onix.  I've check humminbird and minn kota site for any info and can't seem to locate.

Thanks in advance for your help.

Title: Re: Ultera 4 pin connection
Post by: Bob B on May 27, 2015, 10:59:19 PM

Is that an I-pilot link model? 

If so, that is probably the Ethernet connection.

Title: Re: Ultera 4 pin connection
Post by: Wallin8r on May 28, 2015, 07:21:03 AM

Yes it is the link model Bob B. But I hooked up the Ethernet cable that is a 7 pin.
When I pull up transducers on the onix the US2 doesn't show up.

Title: Re: Ultera 4 pin connection
Post by: bobcoy on May 28, 2015, 09:57:52 AM

Most likely that is us2 and you need an adapter to go to the onix

Title: Re: Ultera 4 pin connection
Post by: Wallin8r on May 28, 2015, 10:12:10 AM

That's kind of what I thought too bobcoy. I've looked every where I can find for rigging and adaptors with no luck. I have an email in to humminbird but thought I would try here.  Thanks for the reply this is a great site!

Title: Re: Ultera 4 pin connection
Post by: bobcoy on May 28, 2015, 10:21:34 AM

MKR-US2-13 UNIVERSAL SONAR 2 ADAPTER CABLE-HB ONIX | MFR #1852073
Unfortunately it is $50!

Title: Re: Ultera 4 pin connection
Post by: RonnieB on May 28, 2015, 10:09:42 PM

Read this post, it may help. Greg lined me out. :o
General Discussion / Re: Onix10ciSI, XNT1420T, 360, Ulterra US2

Title: Re: Ultera 4 pin connection
Post by: Wallin8r on May 29, 2015, 06:37:05 PM

Thanks for the help guys!