Humminbird Side Imaging Forums

General => General Discussion => Topic started by: luke on February 01, 2015, 11:46:47 AM

Title: 899 switcher
Post by: luke on February 01, 2015, 11:46:47 AM

Apparently I am going to have to put a switcher on my 899 so I can use it while running. My SI works when not running but everything goes away otherwise. I will probably get a thru hull transducer for this. I am looking for suggestions and comments about this. Best switcher..functionality...cost..install pain...etc. Thanks

Title: Re: 899 switcher
Post by: rnvinc on February 01, 2015, 02:05:24 PM

XP 9 20 T
http://www.humminbird.com/Products/XP-9-20/ (http://www.humminbird.com/Products/XP-9-20/)

AS SIDB Y cable
http://www.humminbird.com/Products/AS-SIDB-Y/ (http://www.humminbird.com/Products/AS-SIDB-Y/)

Installation ...
http://www.bbcboards.net/humminbird-sonar-gps/172972-installation-networking-information-resource.html#post1538600 (http://www.bbcboards.net/humminbird-sonar-gps/172972-installation-networking-information-resource.html#post1538600)

This setup installation is not a "switcher" ...

The AS SIDB Y cable disconnects the wiring channel going to the 2d piezo of the HDSI xducer ... And instead wires in the wiring channel going to the shoot thru XP 9 20 ...

This is a very common installation setup for fiberglass boats ...

Rickie