Humminbird Side Imaging Forums

General => General Discussion => Topic started by: Erino on August 19, 2014, 09:26:55 AM

Title: Lakemaster & XD maps mesh together ?
Post by: Erino on August 19, 2014, 09:26:55 AM

Is there any way to mesh together a lakemaster map with the built in XD map. 

I was fishing the northern part of Lake of the woods Ontario.  Lakemasters chip does not cover 100% of the lake.  The main channels are charted for parts of the lake but not all. So you end up running blind in a lot of those areas.  The base XD map at least gives you some information (sounding depths) for the entire lake.  I wish the 2 could mesh so when your in area where the lakemaster chip gives zero information it would revert back to the XD map.

Title: Re: Lakemaster & XD maps mesh together ?
Post by: Humminbird_Greg on August 19, 2014, 10:10:30 AM

No there is not.  You either select to use the ContourXD maps or a map card from one of the memory card slots.
The only mesh option would be if you created your own AutoChart maps.  There is a transparency layer you could use for that with the ContourXD (or LakeMaster) maps.