Humminbird Side Imaging Forums
General => General Discussion => Topic started by: garm on August 02, 2014, 04:07:11 PM
-
has anybody had trouble with the wire pulling lose at the transducer. Just put this one on in march I was going to ajust the transduce and noticed the wire loose I can see a red wire. I have it mounted on a pontoon boat. I do leave it the water would that cause it to break down the glue seems like it is not in there enough and I can not see why it would come loose I but enough slack so the cable has no pressure on it.would water geeting in it cause any plomlems
-
Call HB ...1-800-633-1468 ...
Do not use that xducer as water may get inside the housing and short out the channels...
It is not normal for the wire strain relief to move in any way that you can actually see the wires inside...
Rickie
-
thanks Rickie going to call when they open
-
garm,
Could you post back what the outcome of this was?
-
sent pictures of the transducer to hb they sent me a new one great service from hb got it on trying out this week