Humminbird Side Imaging Forums
General => General Discussion => Topic started by: Dieago on January 02, 2014, 06:25:22 PM
-
My unit is on a jon boat which I installed a seadoo jet into. why do I have all the prop wash looking turbulent s especially on the right when the jet is 36'' left of the transducer?
-
Welcome to the forum.
Do you have some pictures of your install? That may help a little.
Robert
-
thanks 2/3 of transducer is below boat bottom and its angled a little forward to sit level at trolling speed jet discharge is 6" farther to rear than transducer Im wondering if uper part of beam is seeing aerated water from pump but from what Ive read si sends a ultra thin beam port and starboard and if trans is forward of pump discharge by 6-8''
-
Don,
Does this show up at slower boat speeds?
Does this show up when the motor is off and the boat is drifting?
What about with the motor on but with the boat drifting?
-
Greg not sure at this point because of as today Im the proud new owner of a 999SI :)