Humminbird Side Imaging Forums
General => General Discussion => Topic started by: calli1 on September 19, 2013, 05:43:45 PM
-
Ok....I'm in the process of nailing down what my problem is here. I know it has to do with wires probably touching somewhere. When I added this to my trolling motor...this is on my down image only with some small interference when on side image setting but nothing like this. I have added some filter/chokes but no luck.
This interference is when the trolling motor is not on also. Now...this white looking interference would have continued across if I had left along long enough. Any ideas.......
-
This interference is when the trolling motor is not on also. And if I would have let it...the interference would have covered the entire screen.
-
Its a flaw with the software. I just went through this myself after upgrading software 6.64.
I did a restore and it went away. Run it today for about 3 hrs and still hold good after I installed the 6.740 software update. If you look under the 898 post you will see more info about it.
-
So...what do I need to do.... ? Do I need to restore the software in the unit then ?
-
This is a known bug in the DI Enhance Sharpness setting...(started somewhere around 6.570)...
Set the DI Sharpness to Off...
Rickie
-
Well....went ahead an installed the new 6.740 software. I had already updated my 1198 with this and went online at Humminbird and downloaded the latest for the 898. Seems ok now.
-
Turn the DI Sharpness on and see if HB fixed the this bug in the 6.740...
I have not heard yet...
Rickie