Humminbird Side Imaging Forums

General => General Discussion => Topic started by: honda460ex on March 14, 2013, 01:03:29 PM

Title: TS3 Switch Question...
Post by: honda460ex on March 14, 2013, 01:03:29 PM

I have a TS3 switch wired in my boat for two transducers. To power the TS3 switch's relay it is wired to another 12v toggle switch so that I can cut power at the end of the day. My question is, if that power switch is forgotten off with the unit on and I switch the TS3 switch to position 2 can it damage my unit with no power supplied to the TS3?

Title: Re: TS3 Switch Question...
Post by: Humminbird_Greg on March 14, 2013, 04:08:49 PM

No.  With no power supplied to the TS3 switch the relay will never toggle and will remain in the default 'off' position.  Depending on which transducer is plugged into which connector plug will determine which transducer will be connected by default when the relay is not energized.

Title: Re: TS3 Switch Question...
Post by: honda460ex on March 14, 2013, 04:41:50 PM

AWESOME! Thanks for the info! I love this site. Thanks to all the reading and questions asked I finally have my boat set up just the way I wanted! Thanks again!

Title: Re: TS3 Switch Question...
Post by: Humminbird_Greg on March 15, 2013, 11:49:17 AM

Great to hear.  Now how about some installation and some on-the-water pictures!