Humminbird Side Imaging Forums
Side Imaging Forums => 1197c SI, 1198c SI & 1199ci HD SI => Topic started by: nasdaqsam on July 17, 2012, 09:16:47 AM
-
Hello, Its been a while since I have been on the forum. I have not had as much time as I thought I would to be out and using the sidescan.
Not sure this is the right area for this question if not please advise.
For some reason when I use my navionics card in my computer it shows lake depths but when I use it in the Humminbird it only shows them close to reefs, no where else. I have contacted both Navionics and Humminbird. Both have given me the same response. Humminbird says it is a Navionics problem and Navionics says its Humminbirds. I just want to see depths.
Thanks
Scott
-
Scott,
The Humminbird units allow you to customize what you see.
If you want to see everything:
Under you Chart Menu, set your Chart Detail Level to 'ALL',
and your Spot Soundings to 'Visible'.
That should show you everything your Map chip has to offer.
Good Luck.
-
Spot Sounding to 'Visible'.
Good luck. Roddy
-
Thanks guys. You would think they could have told me that when I called. lol
-
FYI:
The Navionics Premium/Platinum CONTENT-COLORS for timbered area and creeks may not be displaying with 6.180.
So instead of setting Chart Detail Level=ALL, check the following setting.
Chart Detail Level=Custom, then set Custom Chart Layers/Seabed=ON
This was the case on my HB 1197 with 6.180.
-
Update and get past 6.180 to the next one, life will get better fast!
Some people at HB CS may need a little training on the units! Just a little? ::)
Roddy