Humminbird Side Imaging Forums

General => Humminbird Wish List => Topic started by: Gattlin on April 09, 2012, 11:41:58 PM

Title: ALL SI Models - GPS puck die mod
Post by: Gattlin on April 09, 2012, 11:41:58 PM

Model:	ALL SI Models
Suggested Upgrade:	GPS puck die mod
Explanation:	Altering the cast for the gps puck "Upper" :/  base to include a larger hole on one side so the transducer cable can by pass though it.  Lolz after all it's a wish list.   Aka: Skinner
Added in Software Version:
Comments on Update:

Title: Re: ALL SI Models - GPS puck die mod
Post by: Humminbird_Greg on April 10, 2012, 10:23:10 AM

Gattlin,
Can you post a picture of this just so we can be sure of what you are asking?
With just the GPS Receiver by itself: you are talking about the white plastic part that is immediately below the gasket, right?

Title: Re: ALL SI Models - GPS puck die mod
Post by: Gattlin on April 10, 2012, 12:22:17 PM

 Yes that would be the part Greg and below the the gasket is correct ;D  At the bottom edge opposite from each other are the two exit holes just make one a touch bigger :)

Title: Re: ALL SI Models - GPS puck die mod
Post by: Gattlin on April 10, 2012, 12:36:10 PM

Quote from: Gattlin on April 10, 2012, 12:22:17 PM

Yes that would be the part Greg ;D  At the bottom edge opposite from each other are the two exit holes just make one a touch bigger :)

I tried to insert image from my desktop but had no luck I,m doing something wrong :-\

Title: Re: ALL SI Models - GPS puck die mod
Post by: Humminbird_Greg on April 10, 2012, 02:22:18 PM

Image is there now Gattlin and it is the same hole(s) I was thinking that you meant.

Title: Re: ALL SI Models - GPS puck die mod
Post by: sonar2000 on April 10, 2012, 07:50:56 PM

+2   I agree with a second hole.
We have at times wanted a second and had to make it..
thanks for submitting..
chuck

Title: Re: ALL SI Models - GPS puck die mod
Post by: Humminbird_Greg on April 11, 2012, 10:37:43 AM

You guys do realize that you can enlarge the hole yourself in the current design don’t you?  Just flip one of the GPS Receivers over and you will see that you can enlarge the hole with out cutting into the interior of the GPS Receiver itself.

Title: Re: ALL SI Models - GPS puck die mod
Post by: sonar2000 on April 11, 2012, 01:52:02 PM

I dont know if I would enlarge the hole.
I think adding a second hole would not put as much strain on the hole or ring.

Making a hole is simple using a round file. that way you wont slip and drill into something you shouldn't...

chuck