Humminbird Side Imaging Forums
Side Imaging Forums => 798c SI => Topic started by: confusedfisherman on March 25, 2012, 08:38:59 PM
-
i am having problems with the interlink staying connected to my front 787c2i from the console 798cisi
i keep getting a pop up saying disconnected, then 1 second late its connected - it will do this all day long. connections are snug. i have both units with the latest updates. any clues?
-
Try going through the InterLink reset instructions here:
http://www.humminbird.com/FAQ.aspx?ContentId=3080 (http://www.humminbird.com/FAQ.aspx?ContentId=3080)
-
Was this working before? When did it start doing this?
Are there any other issues with the units..
Chuck
-
well, i just recently added it, so this was my first time out with it, that is about the only issue i have with the unit.
-
Try the reset option as Greg mentioned.
It should work right out of the box..
Unless the interlink/software has problems..
Sounds like the unit is ok though..
Chuck
-
ok, maybe i am doing it incorrectly, i tried to repair as stated above but every time i try and connect the interlink it keeps popping up that interlink connection failed.
then its stars again interlink connected and then is disconnected again. could it be there is a cable loose still? i have to boat in my driveway so it is not bouncing around. any thought?
-
Is it possible that it's getting interference from something else on the boat?
Maybe re-check the wire routing. Not sure if GPS could cause it, but I would try
and route the power wires away from GPS and VHF (if you have it).
-
nothing else on boat. no exterior gps, radio or anything.