Humminbird Side Imaging Forums
General => General Discussion => Topic started by: Dragline on January 22, 2012, 01:58:12 AM
-
This may be a simple request but I have had no luck researching it on the web. I have the 798SI with the transom ducer but I want to have a second in hull ducer for sonar reading while at speed when the transom ducer will not work.
I have heard of this being done, if so how is it done and what are the components required and the wiring configuration??
Any help at all would be greatly appreciated
-
This post may help. http://forums.sideimagingsoft.com/index.php?topic=2318.0 (http://forums.sideimagingsoft.com/index.php?topic=2318.0)
-
If you have a fiberglass boat:
XP-9-20 inside-the-hull DualBeam transducer
AS-Si-DB-Y transducer splitter cable
Plug the standard CSi transducer into the plug on the AS-Si-DB-Y cable labeled “Side Imaging”. Plug the XP-9-20 into the plug labeled “DualBeam” and the third connector goes into the unit mounting base in place of the transducer. Launch boat, power unit on and go!