Humminbird Side Imaging Forums

Side Imaging Forums => 898c SI => Topic started by: ferney69 on March 24, 2011, 02:44:03 PM

Title: Ethernet for 898c SI and 788ci
Post by: ferney69 on March 24, 2011, 02:44:03 PM

 I have a 898c SI at the console and a 788ci at the bow,  my 898 has the new 5.4 sw uploaded for ethernet. My question is do I have to wait for a sw upgrade for the 788 before I can share way points between the two units using ethernet? Or...??

Title: Re: Ethernet for 898c SI and 788ci
Post by: Trytoofish on March 24, 2011, 03:25:04 PM

I dont think the 788c is Ethernet capable. You need the new 788 HD for Ethernet capable

Title: Re: Ethernet for 898c SI and 788ci
Post by: Humminbird_Greg on March 24, 2011, 05:09:00 PM

Trytoofish is correct: you have to have one of the new 788ci HD or 788ci HD DI units to be able to have an Ethernet connection to another unit.  The older 788ci units (no “HD” designation in the model number) do not have the Ethernet connector or the circuitry to do this.

If you do have a 788ci HD or 788ci HD DI unit than the 5.410 Ethernet software that you need should be in your Humminbird account.  Load it into your unit and they should start sharing waypoints if connected by the Ethernet cables.

Title: Re: Ethernet for 898c SI and 788ci
Post by: ferney69 on March 24, 2011, 11:35:14 PM

Oh, ok, I see, well will they work with  interlink system then? If so do I have to remove the 5.4 sw version and reload  the 5.2 sw version on my 898c SI?

Title: Re: Ethernet for 898c SI and 788ci
Post by: sonar2000 on March 25, 2011, 01:53:17 PM

Yes it will.  however search this forum  for interlink issues.  The software has problems.  sometimes it may work and for others it does not.....
take some time to do the search.
you will find out a lot....
Chuck

Title: Re: Ethernet for 898c SI and 788ci
Post by: ferney69 on March 25, 2011, 07:13:30 PM

I will do some search for sure then, thanks for your help guys.