Humminbird Side Imaging Forums

General => Articles and Tutorials => Topic started by: TimTDP on February 19, 2022, 09:18:45 AM

Title: Waterproof grommet
Post by: TimTDP on February 19, 2022, 09:18:45 AM

I need to drill a hole to feed a cable to my console. The cable has connections on both ends. I am looking for a waterproof grommet to seal the hole. Or any other method.
Thanks in advance

Title: Re: Waterproof grommet
Post by: rnvinc on February 19, 2022, 11:20:17 PM

Most run the cable up and thru the splashwell drain hole  ... and then back under the rear deck to the console  ...

Is this not an option with your application ..??

Rickie

Title: Re: Waterproof grommet
Post by: TimTDP on February 20, 2022, 12:38:27 AM

Thanks you, but unfortunately not.
I need to run an ethernet cable from my bow-mounted trolling motor. So the cable has to enter the anchor locker.

Title: Re: Waterproof grommet
Post by: danlaboucane on February 20, 2022, 10:06:01 AM

If no grommet fits , marine silicone or sealer can do a good job . some are removable when needed .

Title: Re: Waterproof grommet
Post by: FishinLite on February 21, 2022, 11:01:01 AM

Ypu might want to look at these...

https://www.amazon.com/White-Water-Tight-Cable-Fitting/dp/B079Q64K45 (https://www.amazon.com/White-Water-Tight-Cable-Fitting/dp/B079Q64K45)