Humminbird Side Imaging Forums

Side Imaging Forums => Helix Series Units => Topic started by: emerles on June 09, 2021, 09:31:58 AM

Title: Helix 10 - Arrival Mode "gone"
Post by: emerles on June 09, 2021, 09:31:58 AM: I have updated my Helix10 Mega SI G3N and my iPilot-Link remote with the latest updates (V 2.180) and now the menu item "arrival mode" (iPilot settings) is gone.
Did I make something wrong?
Is there a possibility to "reactivate" the menu item again?

Best regards

Wolfgang
Title: Re: Helix 10 - Arrival Mode "gone"
Post by: rnvinc on June 09, 2021, 10:40:52 PM: Did you try Restore Defaults ... ??

Rickie
Title: Re: Helix 10 - Arrival Mode "gone"
Post by: emerles on June 10, 2021, 09:45:07 AM: Yes, Rickie, I restored the defaults.
Menu Item is still not there.

Additionaly I would like to tell you, that the menu item is also missing at our Helix9 Mega SI G4N.
So, I think it must be a firmware issue.

Is there anything I can do in addition?

Best regards

Wolfgang
Title: Re: Helix 10 - Arrival Mode "gone"
Post by: ezfishn on June 10, 2021, 06:51:56 PM: I don't have access to my boat at the moment to verify but did you check it with the TM deployed? I can't see it at home running a Helix 9 G3N model in Simulator mode but I do remember seeing it previously on an older Helix Gen1 model.
Title: Re: Helix 10 - Arrival Mode "gone"
Post by: emerles on June 11, 2021, 04:09:13 AM: Yes, the motor, network, remote, etc. were running at that time.
Title: Re: Helix 10 - Arrival Mode "gone"
Post by: ezfishn on June 12, 2021, 06:05:59 PM: Was on the boat today and able to confirm the same. Evidently Arrival Mode was removed in the current software.