Humminbird Side Imaging Forums
General => General Discussion => Topic started by: RonnieB on May 12, 2015, 10:04:25 PM
-
A couple of questions on my 360.
>In the 360 manual it shows a "SYSTEM STATUS" - "ACCESSORY TEST" PAGE.
I cannot get to it by the steps in manual..How do I get to it?
>When I deploy my 360, does it start pinging automatically? It does not ask me on screen. But on 360 view it is revolving.
>On Sonar Source for 360 there is a slide switch on right side under "Transducer Setting" that is grayed out on off. What is it and why is it grayed out?
>Can I screenshot 360 view?
-
Ronnie,
Look under the Views menu, at the bottom. There are 3 views that are important to monitor your system:
Self Test
Accessory Test
GPS Diagnostic View
I can't help you with the 360 questions.
-
Those views are not showing up on my Onix?
-
The Accessory view and the System Status view would be available if on a core unit ...
Your Onix is not going to have these pages ...
I don't have a 360 hooked to my Onix to help much ...
You might join this forum and ask your question ... Lots of guys there with 360 ...
http://www.bbcboards.net/humminbird-sonar-gps/486412-humminbird-onix-ion-series-information-resource.html (http://www.bbcboards.net/humminbird-sonar-gps/486412-humminbird-onix-ion-series-information-resource.html)
Rickie