Humminbird Side Imaging Forums
General => General Discussion => Topic started by: riven1950 on April 21, 2010, 07:57:46 AM
-
Just installed my 798ci si and there is a small rubber part left over. The number stamped on it is 407079 and I think that I read that it is only used if you lock down the transducer. Could someone confirm what it is and where / if I need to install it? I do not plan on locking down my transducer.
Thanks,
Ted
-
It sounds like the water spray plug that is suppose to go in the gap between transducer and mount.
-
Yes, that rubber part is the rooster-tail plug for the XNT transducers. Install it and the water spray should go away.
-
Thanks for the reply and info. Hopefully that will solve my rooster tail problem.
TR