Humminbird Side Imaging Forums
Side Imaging Forums => Onix and Ion Series => Topic started by: Cannibul on March 20, 2016, 06:31:33 PM
-
I've been having some problems with my boat.
Went out yesterday and rewired a few things which fixed everything but the 360.
Went out today and tried to get the 360 up. With ONLY the 360 on the circuit it blows a 10 amp fuse RFN.
Put in a 10 amp delay fuse and it blew pretty quick too. However I did note that the shaft of the 360 was HOT before the fuse blew.
At no point was the 360 recognized by the Onix nor could I deploy the motor.
Anyone had a similar experience?
Any ideas?
Thanks.
-
This is definitely not a common problem .... better give HB a call. I don't know what happens to the 360 if the power polarity is accidentally reversed.
-
It's worked in the past. Quit working, then started blowing the fuse later on.
-
If it's hot and blowing fuses it is toast ..... Hope it is still in warranty
-
HB customer service... 1-800-633-1468
Rickie
-
When it rains it pours.
I Pilot remote quit charging today.