Humminbird Side Imaging Forums
General => General Discussion => Topic started by: cokeman6 on July 22, 2009, 07:40:18 PM
-
Ok Here's my problem. Water depth readings are all over the place, especially the numbers after the decimal.
Depth readings were fine with my 797 that was mounted at the console. This year I purchase a 798 and mounted it at the console with a transom mount and moved the 797 to the front of the boat with a trolling motor mount. Both units have the same issue with water depth.
I have tried running one unit at a time, turning off all other electronics, moving the unit from the console to the front of the boat, turning on and off the TVG and adjusting the filter. I also replaced the trolling motor transducer from the SI to the XNT 920 T.
Both units have the newest software.
Help…………..
-
Cokeman6,
Try resetting everything to the factory defaults.
Than switch the Water Type to the Deep Salt water setting and decrease (use a higher number) the Surface Clutter setting.
-
Thanks, Greg. Made the changes today on the water and that fixed the problem. One more question, can I increase the size of my way point names so the a old blind guy (me) can read them going down the lake.
-
That’s not possible Cokeman6. You’ll have to use my optometrists’ solution and get bifocals like me!