Humminbird Side Imaging Forums

General => General Discussion => Topic started by: anvil on July 19, 2014, 11:39:52 AM

Title: one unit two locations
Post by: anvil on July 19, 2014, 11:39:52 AM

planning on buying a 999 si. want to be able to use it on the bridge or down below depending on the weather. Know I will need 2 power cables. Is there a trasducer cable splitter that I can go to both locations?
thanks Roy

Title: Re: one unit two locations
Post by: rnvinc on July 19, 2014, 11:57:13 AM

The US3 switch allows 2 head units (or 2 unit stations)...to be hooked to 1 xducer...

http://www.humminbird.com/Products/US3/ (http://www.humminbird.com/Products/US3/)

You will probably want a second gimbal bracket also...

http://www.humminbird.com/Products/GM-2/ (http://www.humminbird.com/Products/GM-2/)

And you may want a second cable collector...(I could not find this on the HB website)...

Rickie

Title: Re: one unit two locations
Post by: Humminbird_Greg on July 21, 2014, 11:44:18 AM

Make sure that is the correct Connector Collector when you order it Roy.  It needs to be Humminbird part# 540232-1 for the "HD" 800 and 900 series units.  You may have to get this direct from Humminbird.

Title: Re: one unit two locations
Post by: rnvinc on July 22, 2014, 02:08:21 AM

I removed my link to the Collector cable at Amazon because it was the wrong one and I didn't want Anvil buying the wrong one...

Thanks Greg...for inputting the correct part number of the cable collector...

Rickie

Title: Re: one unit two locations
Post by: Sonartech on September 22, 2015, 12:38:09 PM

Just an update on the collector for the internal GPS 800 and 900 units. It is now available as an accessory under part #MBCC-900Ci (740144-1)   http://www.humminbird.com/Products/MBCC-900ci/ (http://www.humminbird.com/Products/MBCC-900ci/)