Humminbird Side Imaging Forums

General => Humminbird Wish List => Topic started by: Goosedwnr on April 24, 2014, 02:40:21 PM

Title: ALL SI Models - Autochart Pro Bottom Hardness Overlay
Post by: Goosedwnr on April 24, 2014, 02:40:21 PM

Model:	ALL SI Models
Suggested Upgrade:	Autochart Pro Bottom Hardness Overlay
Explanation:	I would like the ability to view the Bottom Hardness overlay on my Unit on the water of the lakes I have Mapped and loaded back onto the Autochart Disk.
Added in Software Version:
Comments on Update:

Title: Re: ALL SI Models - Autochart Pro Bottom Hardness Overlay
Post by: pyma6 on May 02, 2014, 11:35:31 PM

Have there been any responses to this question?  I have struggled to figure this out over the past week, without any success.

-Achilles

Title: Re: ALL SI Models - Autochart Pro Bottom Hardness Overlay
Post by: ITGEEK on May 03, 2014, 12:52:22 AM

Autochart is pretty new.
I have no idea what it does, and I'm sure others are
in the same boat.
Wait until people get some experience with it, then
others may chime in.

Title: Re: ALL SI Models - Autochart Pro Bottom Hardness Overlay
Post by: Humminbird_Greg on May 05, 2014, 12:21:15 PM

It looks to me like these are the only responses.
This is a Humminbird Wish List item and not a question, however I also think that this would be a great additional feature for the Humminbird products.  Since fish will relate to different types of bottom, being able to show the relative hardness of an area you have mapped could be beneficial to finding that productive water when you need to.  Just another tool in the ole fisherman’s toolbox.  Please note that this is only possible with the “Pro” version of AutoChart and then only if you build the map from sonar recordings.