Humminbird Side Imaging Forums
Side Imaging Forums => Solix => Topic started by: Skeeter07 on June 01, 2018, 06:48:17 AM
-
Got solix units networked and was picking sonar sources. I picked for depth 1 the transducer that's connected to unit but said selected 2d transducer (Lost). After a few min. lost went away. See picture. Why would lost show when it connected to unit I was setting it up? Also why are there two gps and depth to pick? Is 2 in case number 1 fails? Thanks.
-
Networking is designed to "look for" the next best source if the selected source is lost for any reason ...
A source "Lost" indicates a bad connection or a failing device ...
You might disconnect and reconnect the xducer connector to see if there may be a bad connection ...
Rickie
-
it will also show lost on a transducer that has pinging turned off. there are 2 options for a main and a backup. some options have as many as 4 options
(http://i287.photobucket.com/albums/ll152/troyboy30/Humminbird/snp0413185641_zpsdxqeg26h.jpg)
(http://i287.photobucket.com/albums/ll152/troyboy30/Humminbird/snp0413185652_zpsbqbzrol3.jpg)
(http://i287.photobucket.com/albums/ll152/troyboy30/Humminbird/snp0413185859_zps8vhxphae.jpg)