Humminbird Side Imaging Forums
General => General Discussion => Topic started by: dan8965 on January 13, 2015, 07:56:58 PM
-
Hello I went ice fishing last weekend for the first time using 798 and it was great never go without it again everything worked great but depth was wrong in display but right on flasher and 2d screen itself I have 7.12 software wondering if their was bug in it
-
What was wrong with the depth.Too deep or shallow and how did you measure actual depth? The sonar tab has a depth offset. Bob
-
the 2d graph and flasher would show jig at bottom and show depth at 15 ft the display in corner on 2d and display in center of flasher would be 25 ft one time and maybe 4ft next time moving back and forth between holes everyonce in a while display and graph would match
-
Strange, Maybe set to defaults in case there is a setting causing a problem. I have seen digital depth show shallower than the graph but not deeper. Maybe check the depth offset under the setup tab. It allows a minus or plus 10' adjustment. Bob
-
Thanks I'll try that going to try going out Sunday
-
went out today after default reset and depth display matched 2d graph thanks for the help bobcoy