Side Imaging Forums > Onix and Ion Series
to see left side imaging sides on one screen and right on another
danlaboucane:
how to see left side imaging side on one screen and right on another ? do i need two transducers ? each connected to different units or can i share a different side of the SI by ethernet ?
rnvinc:
The only SI/SI Combo view available is the stacked SI view as seen below with version 1.350 in HELIX series ...(Not sure the version number in ONIX or SOLIX) ...
This view can be created with both left SI data and right SI data coming from the same SI xducer ...
Or from 2 SI xducers using the AS SILR Y cable for HELIX G1 series ...
https://www.humminbird.com/productDetail-Accessory.aspx?Pageid=728&id=977
Or from 2 SI xducers using the SM SILR Y Cable for HELIX MEGA series ...
https://www.humminbird.com/Products/SM-SILRY/
Or from 2 SI xducers using the AS 14 SILR Y Cable for ONIX series ...
https://www.humminbird.com/productDetail-Accessory.aspx?Pageid=728&id=3321
Or from 2 SI xducers using the SM SILR Y Cable for SOLIX series ...
https://www.humminbird.com/Products/SM-SILRY/
-----
Left SI data and right SI data cannot be shared separately thru Ethernet ...
Rickie
danlaboucane:
but if i use two onix SI units connected to two different transducers can i choose to display right side on right screen and left side on the left screen ? and still be ethernet connected ? i would use that when trolling and bring a unit on the bow when casting .
rnvinc:
--- Quote from: danlaboucane on December 03, 2017, 10:46:58 AM ---but if i use two onix SI units connected to two different transducers can i choose to display right side on right screen and left side on the left screen ? and still be ethernet connected ? i would use that when trolling and bring a unit on the bow when casting .
--- End quote ---
I'm afraid not ... Sharing SI thru Ethernet specifies SI from "Unit 1" or SI from "Unit 2" ... which, in effect, requires sharing "left SI data and right SI data"..
There is no selection choice to share "left SI data or right SI data" ...
Rickie
danlaboucane:
ok thanks rickie, but i would still be able to isolate right and left on the two units at console ?
Navigation
[0] Message Index
[#] Next page
Go to full version