Humminbird Side Imaging Forums
Side Imaging Forums => Helix Series Units => Topic started by: pdorman on May 17, 2018, 11:52:41 PM
-
Would like suggestions as to where to install the transducer, just purchased a 4 x12 transducer mounting plate to install also. Thanks in advance. [attachimg=1]
-
The mounting board already on the transom would be a good start as long as there's no rib directly in front of the xducer ...
Rickie
-
I think the current one is a little close to the outboard. Here is the location of mine.
I currently have a SI HD transducer located in the show location. Connected to a Helix 9. I need to tilt the motor up a little but not out of the water.
I now a have a 360 mounted on the left side opposite the HD transducer.
-
with the OB trimmer all the way it and turned all the way that way hold the transducer there and check that the OB won't touch it in a hard turn. You won't have to trim out much for to see to port. I seldom run with the ob trimmed all the way in. Don
-
http://forums.sideimagingsoft.com/index.php?topic=9962.0 (http://forums.sideimagingsoft.com/index.php?topic=9962.0)