Hey Guys,
I recently installed a 899 CI SI on my flat bottom river boat. Like I have on my other boats, I installed the transducer 15" outside of the diameter of the outboard or 21" from center. When I went to test the unit, I'm getting what looks like block out from the skeg &/OR prop.
I know I can install a second transducer to the left of the motor, and if it is blockage, that should fix it.
I wanted to know if anyone has had this happen, and is so, did you have any luck in moving the transducer? If so which direction... I was reading where some users fixed this by moving closer to the outboard about 17" from center.
Thanks!