Humminbird Side Imaging Forums

General => General Discussion => Topic started by: RonnieB on May 12, 2015, 10:04:25 PM

Title: 360 Questions
Post by: RonnieB on May 12, 2015, 10:04:25 PM

A couple of questions on my 360.
>In the 360 manual it shows a "SYSTEM STATUS" - "ACCESSORY TEST" PAGE.
I cannot get to it by the steps in manual..How do I get to it?

>When I deploy my 360, does it start pinging automatically? It does not ask me on screen. But on 360 view it is revolving.

>On Sonar Source for 360 there is a slide switch on right side under "Transducer Setting" that is grayed out on off. What is it and why is it grayed out?

>Can I screenshot 360 view?


 

Title: Re: 360 Questions
Post by: ITGEEK on May 13, 2015, 02:56:01 PM

Ronnie,
Look under the Views menu, at the bottom.  There are 3 views that are important to monitor your system:
Self Test         
Accessory Test     
GPS Diagnostic View

I can't help you with the 360 questions.

Title: Re: 360 Questions
Post by: RonnieB on May 13, 2015, 07:30:45 PM

Those views are not showing up on my Onix?

Title: Re: 360 Questions
Post by: rnvinc on May 13, 2015, 11:49:09 PM

The Accessory view and the System Status view would be available if on a core unit ...

Your Onix is not going to have these pages ...

I don't have a 360 hooked to my Onix to help much ...

You might join this forum and ask your question ... Lots of guys there with 360 ...

http://www.bbcboards.net/humminbird-sonar-gps/486412-humminbird-onix-ion-series-information-resource.html (http://www.bbcboards.net/humminbird-sonar-gps/486412-humminbird-onix-ion-series-information-resource.html)

Rickie