Humminbird Side Imaging Forums
Other Interest => DIY - Side Scan Sonar and towfish => Topic started by: abraquelebout on September 18, 2010, 07:03:27 AM
-
hi
i join a picture take on river for a survey
there's lot of horizontal small line on it and i don't know why
i hope a small vibration...
this picture is at 800 khz
i join the same in 455
rickard do you have an idea?
this picture is take by a 898 si
-
Question: do these horizontal lines show up when viewed on the unit or is this only when viewed with the DeepView software?
-
I think the lines are difficult to see. If this is your main interference problem, I think you are lucky. My images usually show a lot of various sorts of defects, most of them are interference caused by the engine. Did you use the towfish and the long cable at this occasion?
Rickard
-
hi every body
in this sequence i use towfish , 60 meter of cable .
there is only 6 m over the boat and the rest in large buckle on a aluminium boat.
i don't see the interference on the 898, the sreen is smaller than the 1197. i just remark them on deepview. i havent see this small line before
may be electric or eletromagnétic ?
-
It may be from using the HBSI converter. I use a filter in the program to clear up the center water column and that may be what you are seeing in your images.
I can eleiminate it, but there is a lot of clutter.
Robert
-
thank's a lot
yes in deepview this lines come when i use "Color mapping wizard"
but i think there's propeller noise or motor.
in the next archological survey i take care of this.