Soon after I was able to mount my SI transducer (with the help of a few fine folks here on the forum), I connected all cables and went through a power up. All things went fine as I was able to get it into Simulator mode and then normal mode. I then decided to upgrade the software to the 5.410 (had 5.210) via SD card. I reset the defaults then powered down, installed the card with the new software on it and then went to power up and......notta. No lights flickered and the screen stayed black as if I had never touched the power button. Checked the battery and my DMM read 12.5. I don't think it's the battery but I will try a different one and re-check all connections tomorrow.
Questions: Could this be a more serious problem with the unit itself? Could the software update cause this? Would the bootstrap sequence solve this power up problem?
Any help would be great!!
Thanks in advance to all...