Side Imaging Forums > 598c SI HD

598ci Navigation Grid

<< < (3/3)

Swann:
4all I know, it might even be M-capable if therez a way 2tell by looking at the Pins - dunno? So is the main purpose behind using the SI-DB style splitter cable so that 1 can mount something like an In-Hull type XNT9 20 just so that 1 can achieve 2D Readings (83/200khz) at much faster speeds & then once U think U found something of interest, U Slow Right Down & start looking 2 Ur D.I. & S.I. or would there be any other "gained efficiency" by separating/isolating the signal(s) about 2 Transducers? Does it help at all w/picture quality or perhaps allow one 2do 9-10mph vs 4-6mph when applying D.I & S.I or is that just where the buck stops & "Thatz All Folks"? Sandro.

rnvinc:
Correct  ... the benefit of a separate 2d xducer using the AS SIDBY Cable is simply because the SI xducers are challenging to get satisfactory high speed depth readings  ...

Rickie

Navigation

[0] Message Index

[*] Previous page