Side Imaging Forums > Solix

SOLIX SI Single side view places waypoints incorrectly on map view

(1/2) > >>

Arkee:
I have two networked Solix MSI G2 units, one showing left-only SI view and one showing right-only SI View. They share a single transducer through an ethernet switch.  For this explanation, say the SI range is 500ft with each unit is showing a total range of 0-500 ft. The problem is any waypoint marked on the SI view in the 0-250 ft zone shows up on the opposite side of the boat path. Say I marked a rock pile on the LEFT view 100 ft to port side the waypoint is placed about 300ft on the starboard side. A mark made at 250 ft shows up directly under the boat path. It is as if the unit does not recognize the single side view mode and places waypoints relative to a full 1000ft (500 left, 500 right) screen. What is crazy is that the same issue happens in simulation mode which tells me it is not a problem caused by faulty GPS. I have a couple of retired ONIX units and checked them and surprise, they do the same thing.

Anyone know if I am missing another setting for the single-side-only view? I have the Solix units updated to 3.500 and reset to factory defaults trying to fix this problem. So far, Humminbird Support is stumped and I'm pulling my hair out.

rnvinc:
Does the same irregularity happen when a single unit is set to left and right SI on the same display  ...??

Rickie

Arkee:
Yes it does.

rnvinc:
When you mark a waypoint out away from the boat - how are you verifying that waypoint is actually showing on the opposite side of the boat  ...??

Rickie

Arkee:
The mark is placed on the map view.  To test what is happening, I set the SI range to 600 ft then went to the SI-L view and marked three waypoints, one 600 ft left, one at 300 ft and one about 50 from the boat.  On the map view, the first waypoint was set 600 ft left of the boat, the second was set at the boat center and the third was 500 ft right of the boat. 

I also noted the vector (distance, bearing) values on the bottom right of the SI screen that show the location of the cursor when I use the joystick to make those marks starts at 600 ft and reduces to 0 ft at the midpoint of the screen, then goes back to 600 ft at the left edge.

Navigation

[0] Message Index

[#] Next page