Hi there,
Running a 998 on a Harbercraft (aka Kingfisher) boat, and getting the typical poor results at speed - it seems to cut out altogether at about 25 km/h or 15 mph. I have a couple questions.
1. Installation tips. I have the tip of the HDSI transducer a good 1/4" below the transom mounting block. Angled a little back. The hull in this area is not straight, it sort of curves up at the very back. Any tips to get better results on plane?
2. After realizing I could do it, I bought the y cable and will reinstall the old 787c2i transducer so I can get 2d sonar on plane. My question is: will I always have to switch back and forth to do side imaging, or will it sort of take care of itself? I can't seem to yet find specific setup instructions and some mention having to switch back and forth every time they go on plane or off plane.
Any replies will be appreciated - this is a tremendous resource. Thanks.