Humminbird Side Imaging Forums
Side Imaging Forums => 997c SI, 998c SI & 999ci HD SI => Topic started by: MTBob on March 23, 2013, 01:30:47 AM
-
OK, I got the 998c SI unit installed, transducers mounted, cables run and screen "lit up". The water in Montana is still mostly solid so there's no way I can give the outfit a run. So, I'd like to make sure that the transducers & GPS are connected properly and the system is working as it should. Is there a way to tell if the unit is functioning properly while it's sitting in my shop? Is there a system test function?
Bob
-
Yes, there is a diagnostic screen.
I haven't used it in a while, but I think you just have to enable it to be visible and you will see it when cycling thru the views. I think you have to be in advanced mode first.
-
Thanks Bob, I'll check it out.
Bob
-
There is really no way to tell if your system is working correctly until the water thaws.