Humminbird Side Imaging Forums

Side Imaging Forums => 798c SI => Topic started by: jimbo on August 10, 2009, 04:20:24 PM

Title: Case for my 798ci si
Post by: jimbo on August 10, 2009, 04:20:24 PM

I got this from Amazon.com for $37. The Humminbird fits like a glove. The foam is pre sliced so you remove only what you need to.[attachment=1][attachment=2]

Title: Re: Case for my 798ci si
Post by: RGecy on August 10, 2009, 04:50:08 PM

Thanks Jimbo.  I have a 785c2 and needed just this for storage when not in use.  Thanks for the post!

Robert

Title: Re: Case for my 798ci si
Post by: Humminbird_Greg on August 11, 2009, 03:57:59 PM

And it’s yeller!  ;D
(old Humminbird color)

Title: Re: Case for my 798ci si
Post by: jimbo on August 11, 2009, 06:06:03 PM

Greg,  What are the correct part #'s for a through hull Quad Beam transducer and Y cable to use with this unit? Thanx

Title: Re: Case for my 798ci si
Post by: Humminbird_Greg on August 12, 2009, 11:12:47 AM

Do you mean a True Thru-Hull transducer that mounts under the hull via a one-inch hole through the hull?  If yes than look at the XPTH-9-QB-90-T for the plastic version and XBTH-9-QB-90-T for the Bronze version.

If you meant the inside-the-hull type transducer than look at the XP-9-QB-90-T


You cannot use one of the Y-splitter cables with the QuadraBeam transducers (if you were planning on connecting it to the DualBeam side of this cable).  The way that the AS-Si-DB-Y cable is made it will not make connection to the extra side beams of the QuadraBeam transducer when it is connected.
[Now you could connect it to the Side Imaging side of this cable and it would only use the side beams and the temp of the QuadraBeam transducer.]