Humminbird Side Imaging Forums
General => General Discussion => Topic started by: locoengineer on February 15, 2015, 04:35:34 PM
-
I have a 788ci HD DI on the bow, A 899 ci HD SI on the console , and IPILOT Link all hooked to a 5 port Ethernet switch and cannot get the network tabs to come up on either unit. Also it does not show the IPILOT connected. Any ideas?
-
Are you sure the switch is powered correctly?
Maybe try connecting the 2 units directly to each other and see what you get .... and go from there.
-
When I first turned them on, I had the network tab come up on the 788 and even named the unit. Then after that I lost it. I have not checked the power supply yet that was my next move. The other issue is my I Pilot link does not show connected on the 788.
-
Are they all connected thru the 5 port switch? That would be a common point, if it wasn't working none of your networking would work..... Isolate by connecting direct and bypassing the switch.
-
I'll try that, I checked the power to the 5 port switch as you suggested and I think that could be the problem. It would be nice if they had a power light on them so you could tell if you had power. Thanks for the help.