Humminbird Side Imaging Forums
Side Imaging Forums => Helix Series Units => Topic started by: gaj on August 03, 2018, 11:41:29 AM
-
Can I use a spliter cable on my helix 10si to ultrex ipilot link ? already have Ethernet cable run to another helix10 at console
-
HB does not make an Ethernet "splitter" cable ...
*You will need an AS EC QDE adapter cable for each HELIX ... http://www.humminbird.com/Products/AS-EC-QDE/ (http://www.humminbird.com/Products/AS-EC-QDE/)
*You will need AS ETH 5XPG Ethernet switch ... http://www.humminbird.com/Products/AS-EC-QDE/ (http://www.humminbird.com/Products/AS-EC-QDE/)
The AS ETH 5XPG requires 12v power so plan it's installation ...
*Then you will need an Ethernet cable for each HELIX long enough to reach the AS ETH 5XPG switch ... http://www.humminbird.com/Freshwater/Product-Category/Accessories/Cables/?facets=7319, (http://www.humminbird.com/Freshwater/Product-Category/Accessories/Cables/?facets=7319,)
The iLink should have come with an Ethernet cable to reach the AS ETH 5XPG switch ...
Rickie