Humminbird Side Imaging Forums
General => General Discussion => Topic started by: fish-on-bend on November 01, 2011, 05:12:50 PM
-
I just ordered a 788ci hd di. When I install it I want to be able to move it from the dash to the rear when I'm trolling. Whats the easiest way to configure the wiring and transducer cable?
-
Easiest (and most expensive) way would be to set up a second station at the rear of your boat. That would mean a second unit mount (MS-700E), power cable (PC-10) and either a second transducer (XNT-9-DI-T) or a Transducer Switch (TS3).
You may be able to install your unit such that there is enough wire length to use a RAM type mount with two bases and just move the unit with its mount and wiring connected from one location to the other. More of a chance of tripping or snagging the cables this way though.