Topic: Ethernet and two si transducers.

[ranger618]

I just bought an 898 to go with an i-pilot link.
I am thinking about getting another one so I can have one up front and one by the tiller.
I also plan to connect the i-pilot and both units through a 5 port Ethernet switch.
My question is. If I connect a transom mounted si transducer to the rear unit and a trolling motor mounted si transducer to the front unit, will i be able to use either transducer from either unit ?
Will I only be able to use the transducer connected to the unit ?
Will it not work correctly because the units will try to use both transducers at once ?


Thanks.

[Trout Bum]

If you are connected by Ethernet you should be able to use either transducer with eiither graph.

You can choose which transducer, GPS puck, etc. to use with a specific graph by going to the Networking settings screen on each graph and making the selection.

[bobcoy]

Ranger, If you download the ethernet manual. Or use the manual on the dvd that comes with the unit. It expains all the questions I had about what is shared and what is not. Bob