Humminbird Side Imaging Forums

General => General Discussion => Topic started by: Ranger Bob on May 16, 2012, 03:50:03 PM

Title: Temperature display on 898csi
Post by: Ranger Bob on May 16, 2012, 03:50:03 PM

Can someone tell me how to get the water temperature reading to show on the monitor of the 898csi

Title: Re: Temperature display on 898csi
Post by: Double Digit on May 16, 2012, 05:06:12 PM

First make sure your unit is hooked up to the transducer and in the water.... The unit wont show temp if your using the simulation mode not in the water.Then hit the menu button twice open the main menus go to I beleive settings then readouts then pick which readout you want the temp to be shown on...I might not be exact but its close......