Humminbird Side Imaging Forums

Side Imaging Forums => 1197c SI, 1198c SI & 1199ci HD SI => Topic started by: guidoste on August 01, 2013, 05:37:10 AM

Title: Screenproblems on 1197 when connected to a 958
Post by: guidoste on August 01, 2013, 05:37:10 AM

On the boat I have a Humminbird 1197 (used as master with SI Transducer and GPS) With Ethernet connected a Humminbird 958 (Sharing GPS from 1197 and for 2D also from 1197)

When 958 not connected, 2D on the 1197 works fine. When I connect the 958 then the pixels on the Humminbird 1197 (2D mode) becomes bigger. The SI still works fine. On the 958 it works fine.

Software on 1197 - 6.640
Software on 958 - 6.610

Any suggestions?

Title: Re: Screenproblems on 1197 when connected to a 958
Post by: JEVSkeeter on August 02, 2013, 10:37:19 AM

Check your source on the 1197 and make sure you are not trying to use the 958's TD when it's connected.

Title: Re: Screenproblems on 1197 when connected to a 958
Post by: guidoste on August 02, 2013, 10:41:24 AM

Thank you for your reply. On the 958 is no transducer connected. The only transducer is on the 1197.