Topic: 898 unit will not update

[Enufzed]

I have the 5.7 update downloaded to a blank Sandisk Extreme 30mg SD card. Have inserted it into my 898 c SI HB unit for update and it is not reading update to install. Have reset HB to defaults and followed all the correct procedures. Any ideas please guys   

[Enufzed]

No worries I sorted it!!

[RGecy]

What was the problem?

[Enufzed]

Hi Robert,

It would not install FROM a blank SD card (Sandisk 8GB Extreme III 30MG ) with only the new 5.7 update so I copied the update onto another SD card (same as the first) with all my HB folders,= Matrix, Record, ProfileTXT and Snapshot...... Inserted SD card into HB and immediately installed with no apparent problems. Powered the unit off removed the SD card . Powered HB back on again restored the defaults, then went about changing to my personal settings in forced simulator mode after another power off/on. There does not appear to be any fault with the first SD card. The whole deal took place "on bench".

Geoff 

[RGecy]

You may need to reformat the first card and make sure the unit will recognise it.