Humminbird Side Imaging Forums

Side Imaging Forums => Helix Series Units => Topic started by: soopd on February 15, 2018, 12:15:12 PM

Title: Helix 10 Si G2n Mega transducer location
Post by: soopd on February 15, 2018, 12:15:12 PM

I am trying to install a Helix 10 Si G2n Mega transducer on an aluminum SeaArk ZX180. I thought about installing the transducer above the drain plug in front of the lower unit if I have enough clearance. I know I will not get on plane readings, however, I will address that with another transducer where I have one installed now.   Will the drain plug effect my si or my di readings?  Is this a good location?  Any better solutions?

Attached are some pictures of a zx180 that looks like mine. It is not my boat, but my hull is the same hull.

Title: Re: Helix 10 Si G2n Mega transducer location
Post by: rnvinc on February 15, 2018, 09:11:02 PM

The MEGA xducer will work for slow speed scanning above the drain plug  ... This is a similar location to a jackplate mount  ...

You may pick up the additional 2d xducer housing in the right SI  ... It would show as a hard echo line parallel, and to the right of the center line in the SI image  ...

Rickie