Side Imaging Forums > Solix

Solix Thru Hull Transducer Angle

(1/1)

nrgbentall:
Hi, looking for some advise,  below is a photo of the Solix xpth 14 20 msi T.
As the top edge and bottom edge of the transducer are not parallel to each other, can someone please advise which side should be used to set the transducer level to create the best image and object location.

Thanks in advance

Nick

rnvinc:
See if this helps  ...

https://www.humminbird.com/WorkArea/DownloadAsset.aspx?id=3116

Rickie

DennyO:
I had an error on your page Rickie, maybe this was the page you were referring to? Section #3 on the first page deals with I believe his question. Seems to matter what the deadrise is above 2 or below in degrees? It looks like they are using the top surface to me.

https://humminbird.johnsonoutdoors.com/sites/johnsonoutdoors-store/files/product/hbtransducers/1093558/ProductManual/HUM_productmanual_IG_XPTH_SI_532551.pdf?_ga=2.45344228.1103714393.1531687117-1723663000.1531687117

rnvinc:

--- Quote from: DennyO on July 15, 2018, 04:44:28 PM ---I had an error on your page Rickie, maybe this was the page you were referring to? Section #3 on the first page deals with I believe his question. Seems to matter what the deadrise is above 2 or below in degrees? It looks like they are using the top surface to me.

https://humminbird.johnsonoutdoors.com/sites/johnsonoutdoors-store/files/product/hbtransducers/1093558/ProductManual/HUM_productmanual_IG_XPTH_SI_532551.pdf?_ga=2.45344228.1103714393.1531687117-1723663000.1531687117

--- End quote ---

Yes your link is the link I was trying to use  ...

Seems that the block should be cut to allow the bottom face of the xducer to be parallel to the water's surface - thus posting the SI piezoes straight down  ...

Rickie

Navigation

[0] Message Index