Hi again, the pc connect cable rocked up and the bootstrap upload worked
At first it would not even recognise the unit on the PC!? The unit was a brick, after about 10 goes the unit started to come up on the PC screen remain there with just enough time to go to the update step in the file menu tab then drop off, I relised after a few attempts that even though the unit dropped off the screen you can still jog through the update wizard steps just don't send unit lol the unit boots up again in the bootstrap mode then hit send.
Not sure if anybody has had the issue with the unit only temporarily connecting then dropping off into the program fail on the unit before? And the only update it would take up was the latest 6.60!? That happend to be the upload I was using when the unit failed the first time.
Time to hit the water again!