i got up this morning since I was off and what do you know it’s working . Best I can figure I have a bad port in my Ethernet box. All I did after a conversation with Wayne p is to move the connections to a different port on Ethernet. Thanks to everyone on this forum for Input and special shot out to Wayne,Rickie. And FYI even according to huminbird site you can share 360 imaging between solix and helix. Below is literature from huminbird site.
When networked together via Ethernet, HELIX and SOLIX models will share:
Waypoints, Tracks & Routes
GPS signal (not mapping)
i-Pilot Link information and control
360 Imaging
Humminbird CHIRP radar
Bluetooth Talon control**
NMEA 2000 network information
*Depending on technology built into each networked fish finder, some sonar images may not be shared if unable to be supported by your unit’s software. Ensure that you are running the latest software by finding updates here:
https://www.humminbird.com/support/software-updatesSee full compatibility of networking and sonar information here:
https://www.humminbird.com/support/f...etSonarSharing **If both HELIX and SOLIX are on the network and need control of Bluetooth TALONs then at least one SOLIX and one HELIX G2N/G3N must be paired to the Bluetooth TALON at the same time.