WELL it is raining cats and dogs and there is lightning and thunder so now is a good time to ask my
question. I have a 998C SI NVB with the transducer located on the port side near the bottom of the deep V of the transom. Everything works great - even the starboard side image even though the TD is on the Port side and I was worried that the motor/bubbles would cause a problem - no such thing
Even on my very first trip I was able to easily recognize individual rocks that had fallen off of Masonboro Inlet's jetty from over 150' away from the jetty!
However the port side ' image' isn't ie there is just some minor clutter (horizongtal streaks ) and nothing else no matter what setting is used.
Every thing other than this is working better than I had exptected - super solid bottom even at top speed and my setup does not produce any rooster tail. Any thoughts, ideas would be greatly appreciated. Was going to take a picture but see opening sentence.
Any ideas, help, suggestions would be greatly appreciated. I've already learned SO much from this forum that I'm sure I saved a huge amount of time by following the setup ideas presented on this forum. Thanks in advance - cause I KNOW someone will know what to do!
Ray Sanford aka Mako15